Substrate: rubber products, EVA products, TPR synthetic rubber and other elastic materials.
Product examples: balloons, shoe materials (such as rubber outsole) and so on.
Product features: light, ink has a good elasticity, elongation of 3-5 times, especially for EVA material printing, ink is not broken.
Test items | Adhesion | Scratch resistance | Abrasion resistance | Resistant to rubbing | Acid resistance | Alkali resistance | Heat resistance |
Test Results | excellent | 4-5level | 4-5level | 4-5level | 4-5level | 4-5level | 4-5level |
Product Specifications:
project | Hue | Color concentration | Fineness | Viscosity | Gloss | Mobility | Solid content |
Technical Parameters | Refer to the color card | 8%-15% | 5u below | 200-280p | 70-75 | 15-20mm/s | ≥45% |
Instructions for use:
Stencil: 150-300 mesh polyester screen printing plate
Scraping: It is recommended to use 65-85 degree polyurethane plastic scraping
Reference amount: 300 mesh screen printing is about 30 ㎡ / ㎏
Dry: natural dry and dry (dry 10-15 minutes, dry for more than 30 minutes) or 60 ℃ hot air dry
Selection of solvents: the use of RP quick-drying, RP dry, RP slow dry thinner. Due to the printing environment temperature of the appropriate choice
Screen cleaning: the choice of organic solvent cleaning (such as: washing water)
Precautions:
1. The use of the product for printing, due to the variety of rubber, and the structure is also significantly different, this product may not have some rubber products adhesion (such as: silicone rubber, vulcanized rubber), so please use the relevant test.
2. Because of the poor heat resistance of rubber products, long-term placement in high temperature environment is easy to accelerate aging and loss of elasticity, when the prints are broken so the print must be kept in low temperature, dark environment.
3, the use of the ink printing, may be some of the rubber substrate adhesion is not very good, then, you can add the appropriate amount (2% -8%) 9004 or 9005 catalyst to improve adhesion, but must pay attention to the catalyst to add ink Run out in 8 hours.
Product packaging: 1 kg loaded, 5 kg loaded, 20 kg loaded
Storage conditions: 5 ℃ -25 ℃ conditions for two years, to avoid strong light exposure, anti-contact strong acid, alkali.
Reminder:
1, users in the use of this product, please read the instructions, and must test the suitability of different batches of ink, the actual test India, to confirm the qualified before use in bulk;
2, the above conditions in the tolerance test data for the test conditions under the test results, not as a guarantee value.
Dongguan City, a color of Chemical Technology Co., Ltd. www.yanseco.com Chen Jingli 15916853336